Incubation machine maintenance and use

一．Weekly maintenance
Check humidifying water dish.
The switch of inspection door sealing condition.
Check the ventilation.
After cleaning on the ball screw rotation and other sundry, prevent death card.
With damp-dry dishcloth chassis and cabinet external, The young are cleaning machine, each batch add moisture sinks. Cleaning machine and top fluff.
Incubation machine/hatch equipment
Ii. Monthly maintenance content
Check fan, add wet, egg chain is in good condition.
Check heating function.
Check super high temperature alarm function.
Check whether the double function of normal egg.
Thoroughly clean sanitation.
Each batch after hatching are cleaning machine, humidifying birdbath and humidification evaporation.
Incubation machine/hatch equipment
3 maintain. Every three months
Clean the probe.
Calibration of temperature and humidity.
To add a butter fan bearings.
Will double gear oil egg after cleaning buttered lubrication.
After the ball screw and sliding institution with to add the butter.
Add wet, turn to change gear oil eggs. Incubation equipment/LI >
Four of each system. Comprehensive inspection control functions.
For a long time when the machine without maintenance
In a long time before the machine without suspended on heating drying machine, must be humidifying birdbath, the water clean, dry run to wash with butter, protected from rust. It is very important. You decide you don't want a machine, but not by the method to maintain it, so when you want to use it again next time, it might not work, failure.
5. Use the matters needing attention
Incubation equipment operation process, must observe machine working state, every 1 ~ 2 hours once observed, and make record, abnormal condition promptly. Especially door machine table temperature and temperature difference have changed, if there is a change to timely according to requirements.
After control is very important, should check whether appropriate, practical set position are consistent position.
Observation records, egg dish over egg is around two inclined position alternately.
Egg dish push pull must in a horizontal position.
Incubation process if meet the blackout, should be the power switch off the machine, until after the machine to work properly. Use generator power, should pay attention to its output voltage stability and observe all motor rotation direction correctly (self-provided generator and power lines in between electric should change), Blackout machine doesn't work should open the door to hatch machine.
24 hours after incubation period of 96 hours ~, are prohibited during pecked shell use formalin fumigated. Some of the sales of humidity sensor has corrosion disinfectant, not in use in hatch.
Please read carefully the operating instructions and according to execute.